Crown Audio by Harman

Search:     Advanced search
Glossary



When running an IQ for Windows Roll Call the Interface is discoverd but no IQ devices are seen.

1) Verify the cabling of the IQ Bus current loop connectors one of them may be reversed.

2) In the Communications Setup window make sure the proper settings are selected. If connected with an RS-232 cable to an Interface than the the Local RS-232 should be enabled and the "Use RS-232 Current Loop Converter" and IQ Net Enable should not be Checked.

The Current Loop converter was an alternative choice to an IQ System Interface for a while but is no longer avalable.

The IQ Net option is for when using the IQ Net software. The IQ Net software allows a computer to act as a server for the IQ Current Loop devices over an Ethernet. In this case the server computer would be running IQNet and the remote networked computer would be running the IQ for Windows with the IQ Net option engaged.

Others in this Category
document An IQ Client computer, running IQ for Windows, cannot communicate with an IQ Net Server computer.
document My SMX-6/AMB-5 looses memory after a power outage.
document The Monitor Selector thumb wheel doen't work on my SLM-8.
document When trying to display curves, from an SLM-8, the software locks up and crashes.
document My INT-II (INT-2) is not located by IQ for Windows Roll Call
document Using an INT-II (INT-2), IQ for Windows Roll Call doesn't find my devices and only gives a CTS low statement.
document After using a modem and an INTII (INT2) the IQ for Windows Roll no devices are found.
document INT Interface (not INT2) doesn't find components on Loop after moving loop connectors to different Loop.
document INT (not INT2) unable to find or communicate with IQ2 devices.
document Audio polarity of IQ PIP SLM is reversed
document IQ PIP DSP has crackling noise and the noise floor is elevated and input meters show -20 to -15dbu input with no signal input
document I am using an IQ Systems Interface with a USM-810 and USP-2 cards. The USM-810 Control Panel will not load in IQ for Windows and an error code of 16320 is displayed.
document I am using a 10k potentiometer on the USM-810 Control Port and it is not working.
document What PIP modules are compatable with what amps?
document With two or more USM-810's in a IQ system engaging the preset in one of the USM-810's (that is not the Interface) causes the unit to lock up and go offline. Aftera period of time the unit comes back on line.