Crown Audio by Harman

Search:     Advanced search
Glossary



PZM-185 output level vs. Sound Grabber output level

I used to have a Sound Grabber that I loved for its ability to pick up any sound (seemingly regardless of distance). When it finally failed I replaced it with a PZM-180 which I assumed was the same but with different cabling. I have installed a 6V 28a battery and the sensitivity is particularly weak, even when compared to ordinary mics. Will a different battery make a difference? Is there a difference between this and the Sound Grabber? Could there be something else wrong with the PZM-180?
Randall Benton

Reply: A 6V battery is a good choice. A higher-voltage battery will not increase the mic's sensitivity.

The PZM-185 and the discontinued PZM-180 are 8 dB less sensitive than the Sound Grabber, which is about half as loud. That's because the Sound Grabber is high impedance but the PZMs are low impedance. All else being equal, low-impedance mics have lower output than high-impedance mics. To compensate, low-impedance mic inputs generally have more gain than high-impedance mic inputs.

Both the PZM-185 and the PZM-180 have an XLR (3-pin pro audio) connector. Are you plugging that connector directly into your recorder, or are you using some sort of adapter cable (like XLR to mini phone)?

If your recorder has a mini phone jack, there are two ways to increase the output of the PZM-180 or PZM-185. These methods change the PZM from low impedance to high impedance, which increases its output level:

Method 1:
1. Cut the mic cable next to the flex relief of the XLR connector.
2. Strip the cable insulation back 1/2 inch.
3. Solder the white lead to the center tip terminal (the short one) of a mini (1/8") phone plug .
4. Solder the cable shield to the outer sleeve terminal (the long one) of the same mini phone plug.

Method 2:
1. Get a Radio Shack "A3F XLR Jack-to-1/4" Plug Adapter/Transformer ", model 274-016, $14.99.
2. Also get a Radio Shack "Gold-Plated Mono-to-Mono Inline Adapter", model 274-885, $4.99.
3. Plug the PZM XLR connector into the Radio Shack A3F adapter.
4. Plug the 1/4" phone plug on the A3F adapter into the mono-to-mono adapter.
5. Plug the 1/8" phone plug on the mono-to-mono adapter into your recorder.
Others in this Category
document Do PZMs need boundaries to reject sound?
document Can I order your PZM 30D/6D with 1/4" connectors?
document What is the wiring for old PZMs (PZM-30GP, PZM-31S, PZM-6S)?
document Have you a schematic for a PX-T phantom power adapter for an older PZM microphone?
document How do I mount a PZM to a panel? Is a PZM waterproof?
document How do I wire a PZM-10LL to my mixer mic input?
document Which PZM should I choose for drums?
document I want to use a PZM-11 or PZM-11LL with a VCR. What do I need to make the mic work?
document How far can a PZM-11LL mic be from the area I want to record voices from?
document Should I use PZM-11 or PZM-11LL for voice recognition?
document Where to place a PZM-11LL to prevent picking up duct noise?
document Would wireless PZM-30D and PZM-185 mics work to record a conference?
document How can I mike a piano with a PZM without using tape?
document Where can I get information on discontinued PZM microphones?
document How far can I mike a conference with the PZM-10?
document Do you have a wall-mount PZM for voice recognition?
document Where should I place PZM-11LL mics for voice recognition?
document How do I connect a PZM-185 or Sound Grabber II to my camcorder?
document Will PZM-185 mics work for audience miking?
document PZM-11LL signal level too low?
document Choosing the right PZM for recording music
document PZM-185 output level vs. Sound Grabber II output level
document What are the advantages of boundary (surface-mounted) mics like PZM and PCC mics?
document PZM history
document Picking up birds at a nature center
document PZM mounting and waterproofing
document Can the PZM-11LLWR be changed from its line-level output to a mic-level output?
document Miking flute recitals with flat floor mics
document How to mike students and eliminate background noise?
document Sound Grabber II or PZM-185?
document Clandestine listening room