Crown Audio by Harman

Search:     Advanced search
Glossary



PZM-185 output level vs. Sound Grabber II output level

I used to have a Sound Grabber that I loved for its ability to pick up any sound (seemingly regardless of distance). When it finally failed I replaced it with a PZM-180 which I assumed was the same but with different cabling. I have installed a 6V 28a battery and the sensitivity is particularly weak, even when compared to ordinary mics. Will a different battery make a difference? Is there a difference between this and the Sound Grabber? Could there be something else wrong with the PZM-180?
Randall Benton

Reply: Both the PZM-185 and PZM-180 have an XLR (3-pin pro audio) connector. Are you plugging that connector directly into your recorder, or are you using some sort of adapter cable (like XLR to mini phone)?

The PZM-185 and PZM-180 are 8 dB less sensitive than the Sound Grabber, which is about half as loud. That's because the Sound Grabber is high impedance but the PZMs are low impedance. All else being equal, low-impedance mics have lower output than high-impedance mics. To compensate, low-impedance mic inputs have more gain than high-impedance mic inputs.

If your recorder has a mini phone jack, there are two ways to increase the output of the PZM-180 or PZM-185. These methods change the PZM from low impedance to high impedance, which increases its output level:

Method 1:
1. Cut the mic cable next to the flex relief of the XLR connector.
2. Strip the cable insulation back 1/2 inch.
3. Solder the white lead to the center tip terminal (the short one) of a mini (1/8") phone plug .
4. Solder the cable shield to the outer sleeve terminal (the long one) of the same mini phone plug.

Method 2:
1. Get a Radio Shack "A3F XLR Jack-to-1/4" Plug Adapter/Transformer ", model 274-016, $14.99.
2. Also get a Radio Shack "Gold-Plated Mono-to-Mono Inline Adapter", model 274-885, $4.99.
3. Plug the PZM XLR connector into the Radio Shack A3F adapter.
4. Plug the 1/4" phone plug on the A3F adapter into the mono-to-mono adapter.
5. Plug the 1/8" phone plug on the mono-to-mono adapter into your recorder.

Others in this Category
document Should I use a Sound Grabber or GLM-100 to mike a piano?
document How do I connect a PZM-185 or Sound Grabber II to my camcorder?
document How can I convert a Sound Grabber to be phantom powered?
document Why does my Sound Grabber have a low signal level?
document Where should I place a Sound Grabber at a wedding so the sound is not boomy?
document How can I record a rock-group demo with Sound Grabber mics?
document Can the Sound Grabber boundary be clear plastic?
document Will a Sound Grabber II work with a computer sound card?
document How can I power a Sound Grabber II from a sound card?
document How can I record a conference with a Sound Grabber II?
document Will a Sound Grabber II work to pick up students in a classroom?
document What connector mates with a Sound Grabber II? How do I order the Sound Grabber II online?
document Is there a mic extension cable for the Sound Grabber II?
document Miking flute recitals with flat floor mics
document Which Crown microphone has a connector that fits a mini digital camcorder?
document Sound Grabber II or PZM-185?