Crown Audio by Harman

Search:     Advanced search
Glossary



Why are there IQ addresses greater than 250, I thought those were not allowed

TCP/IQ component addresses can be 1 to 65,535. Component addresses are set in software, there are no hardware DIP switches. Each TCP/IQ component on the network must have a unique address., both IQ and TCP/IP. When using a Legacy Gateway: TCP/IQ component addresses are calculated GW+((L-1)*8) + A, where GW is the gateway offset (each gateway on the network must have a unique offset), L is the loop, and A is the component address. On an IQ system connected to a Gateway, component addresses must be unique (e.g. you can't have a mixer at loop 1 address 1 and a PIP at loop 1 address 1).
Others in this Category
document Where can I find retail prices for Crown products?
document How much faster is TCP/IQ than the IQ Bus ?
document How do I assign addresses, either IQ, TCP/IQ, TCP/IP, Subnet Mask, or Cobranet?
document Will the new TCP/IQ products work with the 20 mill current loop products?
document What is a Mac Address?
document Why are there IQ and TCP/IP addresses?
document How do I change a Mac Address?
document What amplifiers do the IQ-PIP-Lite work with?
document When will the BSS 8810C be able to talk TCP/IQ?
document What amplifiers do the IQ-PIP-USP3 work with?
document What amplifiers do the IQ-PIP-USP3/CN work with?
document I have set up a TCP/IP address and a default gateway, but I can not see the products on another VLAN.
document What is the difference between USP3/CN and a USP2/CN?
document What is the difference between IQ-PIP Lite and MEM and SMT?
document Why are there so many addresses, IQ, TCP/IQ, and Mac Address?
document How do I save a preset in a USM-810?
document How do I save a preset on a PIP card?
document How do I assign a control to the USM810 control port?
document How can I lock the front panel of the USM-810?
document How do I readdress components?
document Why does my CTs amplifier show 100% ODEP with USP2 and USP2/CN Cards?
document What are the differences between IQ-PIP modules?
document What are the compatibility issues I need to worry about with IQ-PIP modules?
document How do I store presets in the IQ-USM 810 and IQ-PIP-USP2?
document What Crown IQ components can serve as system interface?
document Why can't I get my PC to communicate with the interface?
document How do I purchase Crown Products?
document I don't know anything about networking. Can I get I-Tech's networking up and running quickly without reading a book or taking a class?
document USM-810 / PS8810 cycles sh1,sh2,sh3,sh4. Can I fix it?
document A USM-810 / PS-8810 shows an "E" error code. What is it?
document What PIP modules are compatable with what amps?
document How do I update the firmware in my CDi, DSi, or XTi amplifier for use with System Architect?