Crown Audio by Harman

Search:     Advanced search
Glossary



How do I copy settings?

One can copy the settings of one channel to another in various ways. Click on "1 > 2" to copy the settings from channel 1 to channel 2 or " 1 < 2" to copy the settings from channel 2 to channel 1. This only works between channel sections within the same USP2 or USP3 control panel. Drag Copy settings from one channel to another. One can copy settings from one unit to another in various ways: Select the unit in the work place and copy (control-c) the settings then select the second unit and paste the settings (control-v) or Drag Copy settings from one unit to another.
Others in this Category
document What are the computer requirements?
document How do I work offline?
document How do I manually add components?
document How do I run a roll call?
document How do I save a file?
document How do I open a file?
document What is Engage?
document What is Upload?
document How do I engage a dataframe?
document How do I upload settings?
document How do I create an Instant New Master?
document How do I remove an Instant New Master?
document How do I save a preset in a USM-810?
document How do I save a preset on a PIP card?
document How do I create custom control pages in IQ for Windows 5.1?
document How do I readdress control page objects?
document How do I save presets to a file?
document What is an attenuator limiter?
document How do I set the power limiters on an I-Tech?
document Why didn't you use the Ethercon connector for the network connection?
document After performing firmware updates to my IQ device(s) or replacing an IQ device with one that has newer firmware, for one that had older firmware, the recalling of a Dataframe file causes the software to report .oif mismatches.