Crown Audio by Harman

Search:     Advanced search

Are you going to produce a lower-cost version of I-Tech?

When compared to retail pricing of competitive amplifiers with similar specifications you will find that I-Tech is priced VERY competitively, and none of those competitive amplifiers have DSP, 200V rails, or global power supply with PFC.
Others in this Category
document How can I-Tech produce so much power with only a 20A plug?
document Isn't Class-I just like other amplifier classes?
document How does I-Tech recycle energy from the load?
document Why is the I-Tech 2 ohm power number smaller than the 4 ohm power number?
document How does Crown measure power?
document What are your 20Hz to 20kHz specs?
document I heard that PFC could cause the mains to sag and shut the amplifier down. Will I-Techs PFC do that?
document I don't want to use your DSP. Can I buy I-Tech without DSP?
document What kind of filters are available in I-Tech's DSP?
document How many filters are available in I-Tech's DSP?
document How much delay is available in I-Tech's DSP?
document What are the adjustment increments for I-Tech's delay setting?
document Will other signal processors work with I-Tech? I don't want to use the on board DSP.
document What is latency, and does I-Tech have a fixed latency?
document If I use I-Tech and Macro-Tech to power a stack, do I have to worry about any delay or time alignment?
document Is post-processed audio available on the analog audio XLR outputs/loop through?
document I cannot find 26dB gain in the sensitivity menu. Is it available in I-Tech?
document What is an attenuator limiter?
document How do I set the power limiters on an I-Tech?
document Why did you put an LCD on the front?
document Do I have to use the LCD?
document How can I keep unauthorized people from tampering with my settings?
document I don't know anything about networking. Can I get I-Tech's networking up and running quickly without reading a book or taking a class?
document What happens if the network breaks or goes down?
document What happens if the amp loses digital signal?
document Are there filters available for the air inlets?
document Are the air filters required? How often should I change them?